Table of Contents

レーザー取得タスクを作成する（E57）

この記事では、E57 形式のレーザー取得タスクの完全なワークフローを説明します。タスク作成、データアップロード、マッピング処理を含み、E57 レーザー取得とマッピングの全工程を標準的に完了できるようにします。

E57 レーザー取得タスクを作成する

After creating a project, click Manage to enter the mapping task management page (skip this step for Mega Go). Click the Laser acquisition task button in the upper-right corner. In the pop-up dialog, enter Task name, select E57 format for Data type, use the latest version for Mapping version and Data format, and click Confirm add to create a Qiyu acquisition task.

Create E57 laser acquisition task

Create E57 laser acquisition task

データ準備

Before starting a mapping task, make sure the acquired spatial data meets the requirements and is organized and stored according to the specifications. The following sections describe data acquisition and export in detail.

データ取得とエクスポート

Use a laser scanner to acquire spatial data. For related device configuration and acquisition points, see:

データをアップロードする

データをアップロード をクリックし、ポップアップウィンドウで対応するオプションを選択します。各オプションの詳細は以下を参照してください: Upload E57 laser mapping data

データの場所

The available upload methods vary depending on the region where the mapping project is located:

China Region 1

Depending on the data source and storage method, you can choose either of the following methods:

  • Local new data
  • Uploaded data (not supported by Mega Go)

Global

Only Local new data is supported.

取得データ

Upload a file with the .e57 suffix. Click Select, choose the specified file in the directory, and click Open. Upload Qiyu laser mapping data

アップロードを確認する

  • After clicking Confirm upload, the list displays the upload progress and status.
  • During data upload, keep the computer powered on and the network connected. Do not close the browser, refresh the page, or click other menus; otherwise the upload will be interrupted and must be performed again.

マッピングを開始する

After data upload is complete, the mapping process starts automatically. The status is displayed as Queued or Generating, as shown below. Wait patiently for mapping to complete.

Mapping task generating

補助機能

The following functions help you manage and operate mapping tasks more efficiently:

アップロード済みファイルを表示する

Click View uploaded files to view all uploaded files in the dialog and confirm that all files have been uploaded, avoiding mapping failures caused by missing files.

View uploaded files

マッピングを停止する

Before the mapping task is complete, if you find that the wrong data was uploaded or the trajectory data does not match the actual situation, click Stop mapping, then click Confirm in the second confirmation dialog to stop mapping.

Stop mapping

タスクを削除する

If the current mapping task failed or is no longer needed, click Delete task to delete it. Click Delete in the second confirmation dialog to complete the deletion.

Delete task

マッピング結果を確認する

After the task enters the mapping process, you can determine whether the mapping task is complete from Task status. When the status is Task complete or Generation failed, the mapping task has ended.

Mapping task complete

マッピング成功

When the task status is Task complete, mapping succeeded and the mapping result has been generated. You can further inspect the result and confirm whether it meets expectations.
View mapping results:

マッピング失敗

When the task status is Generation failed, mapping failed. Troubleshoot the problem as follows:

  • View mapping report: View mapping report and find a solution based on the report information.
  • Refer to troubleshooting: Read the mapping failure troubleshooting guide for common solutions.
  • Contact technical support: If the methods above do not solve the problem, contact EasyAR staff and provide the JobID from the mapping report for fast diagnosis.

関連トピック